HP Integrity rx8620 Server User Service Guide

Figure 6-26 DIMM Removal Tools
3. Seat the tool tips down to limit, then leverage connector latches outward to unseat the DIMM
from the memory slot.
Replacing a DIMM
To replace a DIMM, follow these steps:
1. Orient the replacement DIMM connector key over the memory slot.
2. Using the DIMM installer tool shown in Figure 6-27, press downward evenly to seat the
DIMM into the memory slot.
Figure 6-27 DIMM Installation Tool
3. Position the cover over the cell board and gently press the corners to snap the cover in place.
4. Tighten the four captive screws to secure the cover to the cell board.
5. Replace the cell board into the chassis. See “Replacing a Cell Board” (page 123).
6. Replace the side cover. See “Removing and Replacing Covers” (page 108).
7. Verify proper operation by using the MP Command menu PS command to display cell and
DIMM status for the cell.
Removing and Replacing a Central Processing Unit
The CPUs are located on the cell boards.
Removing the Processor
To remove a processor, follow these steps:
Removing and Replacing a Central Processing Unit 141