HP Integrity rx8620 Server User Service Guide

17. Install the Door Opener (AB388-00003), onto the right side of the cell board. Tighten the
screw. See Figure 6-37.
Figure 6-37 Door Opener Installed
Figure 6-38 VRM Cover and Door Opener Installed
18. Position the DIMM cover in place.
19. To secure the DIMM cover, tighten the four captive screws.
20. Install the cell board in the server.
21. Replace the right side cover.
22. Power on the server. See “Powering Off Hardware Components and Powering On the
Server” (page 106).
23. Verify the firmware and hardware programmable hardware revisions are in standby power
mode by using the MP:CM>SYSREV command. Below is an example of the minimum firmware
version.
152 Removal and Replacement