HP Integrity rx8620 Server User Service Guide

Figure 6-58 PCI OLR Assembly Location (Rear of Server with Top Cover Removed)
Removing the PCI OLR Assembly
Figure 6-59 PCI Gate Detail
NOTE: It is highly recommended that extra PCI gates are available as these may be easily
broken when removing or replacing the gates.
To remove the PCI OLR assembly, follow these steps:
1. Shut down and power off the server.
2. Remove the top and right side covers. See “Removing and Replacing Covers” (page 108).
3. Loosen the captive screws and remove the PCI access panel.
4. Disconnect the PCI OLR cable from the PCI backplane. The connector is located on the cell
board side of the system.
5. Flip all 16 of the PCI gates to the OPEN position.
6. Carefully remove all 16 of the PCI gates, beginning on the OLR cable side of the system (left
side when viewed from the rear of the system).
Removing and Replacing the PCI OLR Assembly 173