HP Integrity rx8620 Server User Service Guide

6. Remove the six bolts from the base attaching the rack to the pallet.
Figure 2-3 Preparing to Roll Off the Pallet
WARNING! Be sure that the leveling feet on the rack are raised before you roll the rack
down the ramp, and any time you roll the rack on the casters. Use caution when rolling the
cabinet off the ramp. A single server in the cabinet weighs approximately 508 lb. It is strongly
recommended that two people roll the cabinet off the pallet.
Securing the Cabinet
When in position, secure and stabilize the cabinet using the leveling feet at the corners of the
base and install the anti-tip mechanisms on the bottom front and rear of the rack.
Figure 2-4 Securing the Cabinet
Rack Mount System Installation
Servers shipped as a standalone or in the to-be-racked configuration must have the core I/O
handles and the PCI towel bars attached at system installation. Obtain and install the core I/O
36 Installation