HP Integrity rx8620 Server User Service Guide

7. Follow the HP J1528A Rack Integration Kit Installation Guide to complete these steps:
• Mounting the server to the slides
• Installing the cable management arm (CMA)
• Installing the interlock device assembly (if two servers are in the same cabinet)
Wheel Kit Installation
Compare the packing list with the contents of the wheel kit before beginning the installation.
Table 2-1 Wheel Kit Packing List
QuantityDescriptionPart Number
2Caster CoverA9904-04002
1Right Side CoverA9904-04007
1Left Side CoverA9904-04008
1Top CoverA9904-04009
1Right Front Caster AssemblyA6093-04082
1Right Rear Caster AssemblyA6093-04083
1Left Front Caster AssemblyA6093-04084
1Left Rear Caster AssemblyA6093-04085
8M4 x 0.7 8mm T15 Steel Zinc Machine Screw (Used to
attach each caster to the chassis)
0515-2478
1Plywood Unloading RampA6093-44013
2Phillips Head Wood Screw (used to attach the ramp to the
pallet)
Not Applicable
Tools Required for Installation
The following list provides the installer with the recommended tools to perform the wheel kit
installation.
• Diagonal side cutters
• Safety glasses
• Torx driver with T-15 bit
• Phillips head screwdriver
WARNING! Wear protective glasses while cutting the plastic bands around the shipping
container. These bands are under tension. When cut, they can spring back and cause serious eye
injury.
To install the wheel kit, follow these steps:
1. Cut and remove the polystrap bands securing the server to the pallet.
2. Lift the carton top from the cardboard tray resting on the pallet.
3. Remove the bezel kit carton and top cushion from the pallet.
40 Installation