HP Integrity rx8620 Server User Service Guide

Top and Side Cover Installation
NOTE: It may be necessary to remove existing top and side covers installed on the server before
installing the covers shipped with the wheel kit. If cover removal is not needed, go directly to
the sections for installing the top and side cover.
Figure 2-14 Cover Locations
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
Removing the Top Cover
To remove the top cover, follow these steps:
1. Connect to ground with a wrist strap.
2. Loosen the blue retaining screws securing the cover to the chassis.
3. Slide the cover toward the rear of the chassis.
4. Lift the cover up and away from the chassis.
5. Place the cover in a safe location.
Wheel Kit Installation 45