HP Integrity rx8620 Server User Service Guide

2. Slide the disk drive into the chassis; a slow, firm pressure is needed to properly seat the
connector.
3. To secure the disk drive in the chassis, press the front locking latch.
4. Spin up the disk by entering one of the following commands:
#diskinfo -v /dev/rdsk/cxtxdx
#ioscan -f
Removable Media Drive Installation
The DVD drive or DDS-4 tape drive is located in the front of the chassis. You must turn off the
server power before attempting to install it. For more information , see .“Powering Off Hardware
Components and Powering On the Server” (page 106)
If an upper drive is installed, you must remove it before installing a lower drive.
To remove the media drive, follow these steps:
1. Remove filler panel.
2. Connect the cables to the rear of the drive.
3. Install left and right media rails and clips.
4. Slide the drive in the chassis. Fold the cables out of the way.
5. The drive easily slides into the chassis; however, a slow, firm pressure is needed for proper
seating.
6. The front locking tab latches to secure the drive in the chassis.
PCI-X Card Cage Assembly I/O Cards
A number of PCI and PCI-X I/O cards are supported in the server. Known supported cards at
the release of this manual are shown in Tables 3-1 through 3-4.
Table 3-1 HP Integrity rx8620 Server I/O Cards - HP-UX
Number of Cards Supported
(B-Bootable)
Card DescriptionPart Number
16FDDI Dual AttachA3739B
16Gigabit Ethernet (1000B-SX)A4926A
16Gigabit Ethernet (1000B-T)A4929A
16
1
Next Generation 1000B-SXA6847A
16???Next Generation 1000B-TA6825A
16???PCI-X Dual Channel 2 GB Fibre Channel HBAA6826A
16Ultra2 SCSIA5149A
162-port Ultra2 SCSIA5150A
16
2
Fibre Channel PCI AdapterA5158A
1610/100B-TX (RJ45)A5230A
164-port 10/100B-TXA5506B
16ATM 155 (MMF connector)A5513A
16Token Ring (4/16/100 Mb/s)A5783A
162-port Ultra2-SCSI + 2-port 100TA5838A
8Hyperfabric IIA6386A
16???PCI-X Dual Channel 2Gb Fibre Channel HBAA6826A
50 Installing Accessories