HP Integrity rx8620 Server User Service Guide

command. For details, see the Interface Card OL* Support Guide located on the HP website
at http://hp.com.
9. Replace the top cover.
10. Connect all cables to the installed PCI card.
DVD+RW Installation Instructions
The CD/DVD/DAT is located in the front of the chassis. The system power to this component
must be removed before attempting to remove or replace it.
Figure 3-3 Removable Media Bay Location
To install the DVD+RW drive, follow these steps:
1. Remove the front bezel and top cover. See “Removing the Front Bezel” (page 111), and
“Removing the Top Cover” (page 45).
2. Remove the drive bay blank or removable media drive.
NOTE: You must remove the upper removable media drive to access the lower removable
media drive.
3. Remove the DVD+RW drive from package.
4. Install the side rails onto the drive.
5. Connect the removable media bay power cable to the loose end of the Y power cable on the
DVD+RW assembly. Ensure that the mating connector pair passes through the ruggedizer.
6. Route the removable media bay power cable into the ruggedizer cable clip.
7. Connect the SCSI cable to the DVD+RW dive. Ensure that the power cable passes over the
top of the SCSI cable.
8. Slide the DVD+RW drive and cable into the removable media drive bay. Push the drive until
it is fully seated in the bay.
Installing Add-On Products 55