HP Integrity rx8620 Server User Service Guide

3. Log in to the MP:
a. Enter Admin at the login prompt. (This term is case-sensitive.)
It takes a few moments for the MP prompt to appear. If it does not, be sure the laptop
serial device settings are correct: 8 bits, no parity, 9600 baud, and None for both Receive
and Transmit. Then, try again.
b. Enter Admin at the password prompt. (This term is case-sensitive.)
The MP Main Menu displays:
Figure 4-12 MP Main Menu
Configuring LAN Information for the MP
This section describes how to set and verify the server MP LAN port information. LAN
information includes the MP network name, the MP IP address, the subnet mask, and gateway
address. This information is provided by the customer.
To set the MP LAN IP address, follow these steps:
1. At the MP Main Menu prompt (MP>), enter cm. From the MP Command Menu prompt
(MP:CM>), enter lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is a good
idea to write down the information or log it to a file, as it may be required for future
troubleshooting.
NOTE: If the Command Menu is not shown, enter q to return to the MP Main Menu, then
enter cm.
2. Enter lc and press the Return key. The following screen displays:
68 Cabling and Power Up