HP Integrity rx8620 Server User Service Guide

Table 5-7 Core I/O LEDs (continued)
DescriptionStateDriven byLED (as silk-screened
on the bulkhead)
Core I/O not fully seated or the MP
processor is being reset
On YellowMP FAULT
Indicates MP LAN activityOn GreenMP LAN controllerMP LAN ACT
MP LAN in 10 BT modeOn GreenMP firmware controlledMP LAN 10 BT
MP LAN in 100 BT modeOn GreenMP firmware controlledMP LAN 100 BT
MP LAN link is OKOn GreenMP LAN controllerMP LAN LINK
Indicates SYS LAN activityOn GreenSystem LAN controllerSYS LAN ACT
SYS LAN in 10 BT modeOn GreenSystem LAN controllerSYS LAN 10 BT
SYS LAN in 100 BT modeOn GreenSystem LAN controllerSYS LAN 100 BT
SYS LAN in 1Gb modeOn GreenSystem LAN controllerSYS LAN 1Gb
SYS LAN full duplex activityOn GreenSystem LAN controllerSYS LAN FDUP
SYS LAN link is okOn GreenSystem LAN controllerSYS LAN LINK
SCSI LVD mode (on = LVD, off = SE)On GreenSystem SCSI controllerSCSI LVD
SCSI termpower is onOn GreenSystem SCSI controllerSCSI TRM
I/O power onOn GreenLBA on system backplanePWR
PCI attentionOn YellowLBA on system backplaneATTN
Core I/O Buttons
There are two recessed buttons on the back of the core I/O card, as explained in Table 5-8.
Figure 5-8 Core I/O Button Location
HP Integrity rx8620 Server LED Indicators 89