Installation Guide, Sixth Edition - HP Integrity rx8620 Server

Chapter 2
Installation
Receiving the Server Cabinet
34
Step 4. Remove the packing materials.
CAUTION The plastic wrapping material should be cut off rather than pulled off. Pulling the
plastic covering off represents an ESD hazard.
Step 5. Remove the four bolts holding down the ramps and remove the ramps.
NOTE Figure 2-2 shows one ramp attached to the pallet on either side of the cabinet with
each ramp secured to the pallet using two bolts. There is another configuration
where the ramps are secured together on one side of the cabinet with one bolt.
Figure 2-2 Removing the Shipping Bolts and Plastic Cover