SmartSetup Scripting Toolkit Deployment Guide for HP Integrity Servers with Windows Server 2003 and Windows Server 2008 for Itanium-based Systems

SetWS2003.cmd, SetWS2008.cmd
Optional scripts for configuring a deploy
action manually from the command
prompt. If you use these scripts, you do
not need to reconfigure the
SSTKConfig.cmd file. These scripts set
the os_deploy variable to WS2003 or
WS2008, and the default_action
variable to deploy. You can run them
after running SSTKStart.cmd from the
command prompt. Then, run either
DeployWS2003.cmd or
DeployWS2008.cmd to begin the
deployment process.
ApplyArrayConfiguration,
CaptureArrayConfiguration
Run the hpacubin utility.
ApplySaSConf
Applies RAID 1 configuration to an LSI
1068 controller, as required for Windows
Installation. See “applysasconf action”
(page 25).
SSTKLogInit, SSTKLogger
Manages the SSTK log system. See “SSTK
log file” (page 34).
CopyISP, PostInstall2003,
PostInstall2008, CopyDrivers
After Windows installation, the
post-Install script calls the Integrity
Support Pack (ISP) installer if ISP
installation files are available on the
repository. In addition, the
Copydrivers script is used for copying
PnP Drivers required for Windows Server
2003 installation. For information on
configuring the SSTK repository, see
“Uploading the Windows installation
files” (page 26).
diskpart\default_layout_2003.txt A diskpart script that specifies the
installation disk partition layout for
Windows 2003.
diskpart\default_layout_2008.txt A diskpart script that specifies the
installation disk partition layout for
Windows 2008.
software
Contains ISP installation files and additional software to be installed after the
operating system is initially installed. See “Uploading Integrity Support Pack
6.1” (page 27).
utilities
Contains the toolkit utilities. For complete information on each SSTK utility,
see Chapter 6 (page 41).
Extracting the SSTK package 15