HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

After unpacking the cabinet, examine it for damage that might have been obscured by the shipping
container. If you discover damage, document the damage with photographs and contact the
transport carrier immediately.
If the equipment has any damage, the customer must obtain a damage claim form from the shipping
representative. The customer must complete the form and return it to the shipping representative.
Securing the Cabinet
When in position, secure and stabilize the cabinet using the leveling feet at the corners of the base
(Figure 15). Install the anti-tip mechanisms on the bottom front and rear of the rack.
Figure 15 Securing the Cabinet
Standalone and To-Be-Racked Systems
Servers shipped in a stand-alone or to-be-racked configuration must have the core I/O handles
and the PCI towel bars attached at system installation. Obtain and install the core I/O handles
and PCI towel bars from the accessory kit A6093-04046. The towel bars and handles are the
same part. See service note A6093A-11. This is the same accessory kit used for the HP 9000
rp8400 server.
Rack-Mount System Installation
Information is available to help with rack-mounting the server. This list is intended to guide the HP
Installation Specialist to the documentation that has been written by the Rack and Power team.
See the following website: http://www.hp.com/go/bizsupport
The web site is organized into the following topics:
Racks & Accessories
• Rack System/E
• Rack accessories
• Universal mounting kits
28 Installing the System