HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

WARNING! Use caution when using the lifter. To avoid injury, because of the weight of the
server, center the server on the lifter forks before raising it off the pallet.
Always rack the server in the bottom of a cabinet for safety reasons. Never extend more than one
server from the same cabinet while installing or servicing another server product. Failure to follow
these instructions could result in the cabinet tipping over.
1. Obtain the HP J1528B Rack Integration Kit Installation Guide before proceeding with the
rack-mount procedure. This guide covers these important steps:
• Installing the anti-tip stabilizer kit (A5540A)
• Installing the ballast kit (J1479A)
• Installing the barrel nuts on the front and rear columns
• Installing the slides
2. Follow the instructions on the outside of the server packaging to remove the banding and
carton top from the server pallet.
3. Insert the lifter forks between the cushions (Figure 16).
Figure 16 Positioning the Lifter to the Pallet
Position the Lifter
Forks at These
Insertion Points
4. Carefully roll the lift forward until it is fully positioned against the side of the server.
5. Slowly raise the server off the pallet until it clears the pallet cushions (Figure 17).
30 Installing the System