HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

Figure 27 Side Cover Detail
Retaining Screw
3. Slide the cover from the chassis toward the rear of the system.
4. Place the cover in a safe location.
Installing the Side Cover
The following section describes the procedure for installing the side cover.
1. Orient the cover according to its position on the chassis.
2. Slide the cover into position using a slow, firm pressure to properly seat the cover.
3. Tighten the blue retaining screw securing the cover to the chassis.
Installing the Power Distribution Unit
The server may ship with a power distribution unit (PDU). Two 60 A PDUs are available for the
server. Each PDU is 3U high and is mounted horizontally between the rear columns of the server
cabinet. The 60 A PDUs are delivered with an IEC-309 60 A plug.
The 60 A NEMA
2
PDU has four 20 A circuit breakers and is constructed for North American use.
Each of the four circuit breakers has two IEC
3
-320 C19 outlets providing a total of eight IEC-320
C19 outlets.
The 60A IEC PDU has four 16 A circuit breakers and is constructed for International use. Each of
the four circuit breakers has two IEC-320 C19 outlets providing a total of eight IEC-320 C19
outlets.
Each PDU is 3U high and is rack-mounted in the server cabinet.
Documentation for installation will accompany the PDU. The documentation can also be found at
the following website: http://www.hp.com/go/bizsupport
2. NEMA: National Electrical Manufacturers Association.
3. IEC: International Electrotechnical Commission.
Installing the Power Distribution Unit 39