HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

This PDU might be referred to as a Relocatable Power Tapoutside HP.
The PDU installation kit contains the following:
• PDU with cord and plug
• Mounting hardware
• Installation instructions
Installing Additional Cards and Storage
This section provides information on additional products ordered after installation and any
dependencies for these add-on products.
The following options can be installed in the server:
• Hard disk drive storage
• Removable media device storage
• PCI/PCI-X I/O cards
Installing an Additional Hard Disk Drive
The disk drives are located in the front of the chassis (Figure 28). The hard disk drives are hot-plug
drives.
A list of replacement disk drives for the server is in Appendix A of the HP Service Guide. The list
contains both removable media disk drives and hard disk drives.
Figure 28 Disk Drive Location
Hard Disks
Use the following procedure to install the disk drives:
1. Be sure the front locking latch is open, then position the disk drive in the chassis.
2. Slide the disk drive into the chassis; apply a slow, firm pressure to properly seat the connector.
40 Installing the System