HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

Figure 39 Four Cell Line Cord Anchor (rp8400, rp8420, rp8440, rx8620, rx8640)
2. Tighten the captive thumbscrews to secure the line cord anchor to the chassis.
3. Weave the power cables through the line cord anchor. Leave enough slack that the plugs can
be disconnected from the receptacles without removing the cords from the line cord anchor
4. Use the supplied Velcro straps to attach the cords to the anchor. See Figure 40: “Line Cord
Anchor and Velcro straps”,
Figure 40 Line Cord Anchor and Velcro straps
Velcro Straps
MP Core I/O Connections
Each HP server has at least one core I/O card installed. Each core I/O card has a management
processor (MP). If two core I/O cards are installed, this allows for two partitions to be configured
or enables core I/O redundancy in a single partition configuration. Each core I/O card is oriented
vertically and accessed from the back of the server.
Use the core I/O board to update firmware, access the console, turn partition power on and off,
and utilize other features of the system.
58 Installing the System