HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

3. Log in to the MP:
1. Enter Admin at the login prompt. (This term is case-sensitive.)
It takes a few moments for the MP> prompt to appear. If the MP> prompt does not appear,
verify that the laptop serial device settings are correct: 8 bits, no parity, 9600 baud, and
None for both Receive and Transmit. Then try again.
2. Enter Admin at the password prompt. (This term is case-sensitive.)
The MP Main Menu is displayed:
Figure 44 MP Main Menu
Configuring LAN Information for the MP
This section describes how to set and verify the server management processor (MP) LAN port
information. LAN information includes the MP network name, the MP IP address, the subnet mask,
and gateway address. This information is provided by the customer.
To set the MP LAN IP address:
1. At the MP Main Menu prompt (MP>), enter cm.
NOTE: If the Command Menu does not appear, enter q to return to the MP Main Menu,
then enter cm..
2. From the MP Command Menu prompt (MP>CM:), enter lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is a good idea
to write down the information or log it to a file, because it may be required for future
troubleshooting.
Enter lc and press the Return key. The lc command is displayed as shown in Figure 45.
62 Installing the System