HP Integrity rx8640 and HP 9000 rp8440 Servers Installation Guide

11. A screen similar to Figure 46 will display allowing verification of the settings.
Figure 46 The ls Command Screen
To return to the MP Main menu, enter ma.
To exit the MP, enter x at the MP Main Menu.
Accessing the Management Processor via a Web Browser
Web browser access is an embedded feature of the management processor (MP). The Web browser
enables access to the server via the LAN port on the core I/O card. MP configuration must be
done from an ASCII console.
NOTE: The MP has a separate LAN port from the system LAN port. It requires a separate LAN
drop, IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, gather the following information:
• IP address for the MP LAN
• Subnet mask
• Gateway address
• Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, perform the following steps:
1. Connect to the MP using a serial connection.
2. Configure the MP LAN. See “Configuring LAN Information for the MP”.
3. Type cmto enter the Command Menu.
4. Type sa at the MP:CM> prompt to display and set MP remote access.
64 Installing the System