HP Integrity rx8640, HP 9000 rp8440 Server User Service Guide

Table 32 Core I/O Buttons (continued)
FunctionLocationButton Identification (as
silk-screened on the
bulkhead)
NOTE: If the MP RESET button is held for longer than five
seconds, it will clear the MP password and reset the LAN,
RS-232 (serial port), and modem port parameters to their default
values.
LAN Default Parameters
• IP Address - 192.168.1.1
• Subnet mask - 255.255.255.0
• Default gateway - 192.168.1.1
• Hostname - gsp0
RS-232 (Serial Port) Default Parameters
• 9600 baud
• 8 bits
• No parity
Remote/Modem Port Parameters
• Disabled
Request OL* for this core I/O slotTo the far right side of the
core I/O card
OLR (Symbol next to
button is shown below)
NOTE: The OLR function is not enabled for the core I/O card.
Disk Drive LEDs
There are two tri-color LED on each disk drive.
Figure 58 Disk Drive LED Location
Activity
LED
Status
LED
Table 33 Disk Drive LEDs
DescriptionFlash RateStatus LEDActivity LED
Normal operation, power appliedSteadyGreenOff
Green stays on during foreground drive self-testSteadyOffGreen
Server LED Indicators 121