HP Integrity rx8640, HP 9000 rp8440 Server User Service Guide

Table 19 Wheel Kit Packing List (continued)
QuantityDescriptionPart Number
8M4 x 0.7 8mm T15 steel zinc machine screw (used to attach
each caster to the chassis)
0515-2478
1Plywood unloading rampA6093-44013
2Phillips head wood screw (used to attach the ramp to the
pallet)
Not Applicable
Tools Required for Installation
Use the following tools to perform the wheel kit installation:
• Diagonal side cutters
• Safety glasses
• Torx screwdriver with T-15 bit
• Phillips head screwdriver
WARNING! Wear protective glasses while cutting the plastic bands around the shipping container.
These bands are under tension. When cut, they can spring back and cause serious eye injury.
Use the following procedure to install the wheel kit.
1. Cut and remove the polystrap bands securing the server to the pallet.
2. Lift the carton top from the cardboard tray resting on the pallet.
3. Remove the bezel kit carton and top cushions (Figure 16) from the pallet.
Figure 16 Server on Shipping Pallet
Top Cushions
Bezel Kit
Cardboard Tray
Shipping Pallet
4. Unfold bottom cardboard tray.
40 Installing the System