HP Integrity rx8640, HP 9000 rp8440 Server User Service Guide

Main Menu: Enter command or menu > path
Primary Boot Path: 0/0/2/0/0.13
0/0/2/0/0.d (hex)
HA Alternate Boot Path: 0/0/2/0/0.14
0/0/2/0/0.e (hex)
Alternate Boot Path: 0/0/2/0/0.0
0/0/2/0/0.0 (hex)
Main Menu: Enter command or menu >
3. Boot the device by using the boot command from the BCH interface.
You can issue the boot command in any of the following ways:
• boot
Issuing the boot command with no arguments boots the device at the primary (PRI) boot
path.
• boot bootvariable
This command boots the device indicated by the specified boot path, where
bootvariable is the PRI, HAA, or ALT boot path.
For example, boot pri boots the primary boot path.
• boot lan install or boot lan.ip-address install
The boot...install commands boot HP-UX from the default HP-UX install server or
from the server specified by ip-address.
• boot path
This command boots the device at the specified path. You can specify the path in HP-UX
hardware path notation (for example, 0/0/2/0/0.13) or in path label format (for
example, P0 or P1).
If you specify the path in path label format, then path refers to a device path reported
by the last search command.
After you issue the boot command, the BCH interface prompts you to specify whether
you want to stop at the ISL prompt.
To boot the /stand/vmunix HP-UX kernel from the device without stopping at the ISL
prompt, enter n to automatically proceed past ISL and execute the contents of the AUTO
file on the chosen device. (By default, the AUTO file is configured to load /stand/
vmunix.)
Main Menu: Enter command or menu > boot pri
Primary Boot Path: 0/0/1/0/0.15
Do you wish to stop at the ISL prompt prior to booting? (y/n) >> n
ISL booting hpux
Boot
: disk(0/0/1/0/0.15.0.0.0.0.0;0)/stand/vmunix
To boot an HP-UX kernel other than /stand/vmunix, or to boot HP-UX in single-user or
LVM-maintenance mode, stop at the ISL prompt and specify the appropriate arguments
to the hpux loader.
Booting and Shutting Down HP-UX 89