HP Integrity rx8640, HP 9000 rp8440 Server User Service Guide

3. At the EFI Shell environment, issue the map command to list all currently mapped bootable

devices.

The bootable file systems of interest typically are listed as fs0:, fs1:, and so on.

4. Access the EFI System Partition for the device from which you want to boot HP-UX (fsX: where

X is the file system number).

For example, enter fs2: to access the EFI System Partition for the bootable file system number

2. The EFI Shell prompt changes to reflect the file system currently accessed.

The file system number can change each time it is mapped (for example, when the nPartition

boots, or when the map -r command is issued).

5. When accessing the EFI System Partition for the desired boot device, issue the HPUX command

to initiate the HPUX.EFI loader on the device you are accessing.

The full path for the loader is \EFI\HPUX\HPUX.EFI. When initiated, HPUX.EFI references

the \EFI\HPUX\AUTO file and boots HP-UX using the default boot behavior specified in the

AUTO file.

You are given 10 seconds to interrupt the automatic booting of the default boot behavior.

Pressing any key during this 10-second period stops the HP-UX boot process and enables you

to interact with the HPUX.EFI loader. To exit the loader (the HPUX> prompt), enter exit (this

returns you to the EFI Shell).

To boot the HP-UX OS, do not type anything during the 10-second period given for stopping

at the HPUX.EFI loader.

Shell> map

Device mapping table

fs0 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)/HD(Part1,Sig72550000)

blk0 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)

blk1 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)/HD(Part1,Sig72550000)

blk2 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)/HD(Part2,Sig72550000)

blk3 : Acpi(000222F0,2A8)/Pci(0|0)/Scsi(Pun8,Lun0)

blk4 : Acpi(000222F0,2A8)/Pci(0|1)/Scsi(Pun2,Lun0)

Shell> fs0:

fs0:\> hpux

HP-UX Boot Loader for IA64 Revision 1.723

Press Any Key to interrupt Autoboot

\efi\hpux\AUTO ==> boot vmunix

Seconds left till autoboot - 9

6. Exit the console and management processor interfaces if you are finished using them.

To exit the EFI environment, press ^B (Control+B); this exits the nPartition console and returns

to the management processor Main Menu. To exit the management processor, enter X at the

Main Menu.

Single-User Mode HP-UX Booting

This section describes how to boot HP-UX in single-user mode on cell-based HP Integrity servers.

• On HP 9000 servers, to boot HP-UX in single-user mode, see “Single-User Mode HP-UX Booting

(BCH Menu)”.

• On HP Integrity servers, to boot HP-UX in single-user mode, see “Single-User Mode HP-UX

Booting (EFI Shell)” (page 93).

Booting and Shutting Down HP-UX 91