Installation Guide, Third Edition - HP Integrity rx8640 SEU

IMPORTANT: The SEU must be mounted in the same rack as the server to which it will be
connected. The unit must also be mounted directly above the server in the same rack cabinet.
Any SEU installed into a rack is shipped with equipment slides. With every set of slides comes
an installation guide: installation guide, hp J1530B, rack integration kit (lower case intended). Follow
the steps in this installation guide to determine where and how to place the SEU into the rack
before proceeding with Step 1. The installation guide may also be found on the Web at
http://www.hp.com/racksolutions
1. Follow the instructions on the outside of the server packaging to remove the banding and
carton top from the server pallet.
2. Remove all cartons from the pallet, leaving only the SEU.
3. Position the RonI lifter as shown in Figure 2-6.
Figure 2-6 Positioning RonI Lifter with the SEU Pallet
4. Insert the lifter forks under the SEU.
5. Carefully roll the lift forward until it is fully positioned against the side of the SEU.
6. Slowly raise the SEU off the pallet until it clears the pallet cushions.
Unpacking a Non-Racked SEU 29