Installation Guide, Third Edition - HP Integrity rx8640 SEU

PCI IO Card Installation
CAUTION: While the installation process for PCI/PCI-X cards and PCIe cards is the same; PCIe
cards are physically smaller than PCI-X cards and are not interchangeable with PCI/PCI-X cards.
Check Table 1-8 (page 20) to verify the slot types and order.
NOTE: The PCI IO card installation process varies depending on which version of the HP-UX
operating system you are running on your system. PCI IO card installation procedures should
be downloaded from the http://docs.hp.com/ Web site. Background information and procedures
for adding a new PCI IO card using online addition are found in:
• HP System Partitions Guide for HP-UX 11.11
• Interface Card OL* Support Guide for HP-UX 11.23
1. Consult the appropriate guide for instructions on preparing the operating system for the
online addition of the PCI IO card before attempting to insert a PCI IO card into the PCI-X
assembly backplane slot.
2. Remove the top cover.
3. Open the manual retention latch (MRL). See Figure 2-9 for details.
Figure 2-9 Manual Retention Latch Detail
4. Remove the PCI bulkhead filler panel.
5. Position and seat the PCI card in the slot.
NOTE: A slow, firm pressure is needed to properly seat the card into the connection.
6. Rotate the MRL to the closed position.
Installing Accessories 35