LIFT-O-FLEX® 17000 SP 400 Manual

Lift-O-Flex 17000 SP 400 Manual
Page 5 Rev July 01
3. Pick up the lift mast and carefully insert the mast onto the mounting slide. (A mounting slot is
provided full length on the rear of the mast). Slide the mast onto the mounting slide until it mates
with coupling located at the bottom of the intermediate section. (If the coupling does not seat
properly, lift the mast up approximately 2” from the intermediate section, lift up on the end-
effector mounting yoke (this will turn the coupling on the lift mast) and push the mast into
position). An indicator line is provided on each mast that matches the top of the lift mast
mounting yoke. This must be aligned for proper operation of the lifter.
4. Tighten the handle on the back of the mounting yoke.
Bolted Intermediate Section
Lift Motor Intermediate Section-Lock in
Place with Quick Disconnect Pin Located on
Bolted Intermediate Section Bracket.