User Service Guide, Fifth Edition - HP Integrity rx8640 SEU

Figure 3-8 Embedded Disks
Hard Disk Drive Installation
The disk drives are located in the front of the chassis. The hard disk drives are hot-plug drives.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to
follow ESD safety precautions could result in damage to the SEU.
1. Be sure the front locking latch is open, then position the disk drive in the chassis.
2. Slide the disk drive into the chassis; a slow, firm pressure is needed to properly seat the
connector.
3. Press the front locking latch to secure the disk drive in the chassis.
4. Spin up the disk by entering one of the following commands:
#diskinfo -v /dev/rdsk/cxtxdx
#ioscan -f
Removable Media Drive Installation
The DVD drive or DDS-4 tape drive is located in the front of the chassis.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to
follow ESD safety precautions could result in damage to the SEU.
1. Remove filler panel.
2. Connect the cables to the rear of the removable media drive.
3. Install left and right media rails and clips.
4. Slide the drive in the chassis. Fold the cables out of the way.
The drive easily slides into the chassis; however, a slow, firm pressure is needed for proper
seating. The front locking tab will latch to secure the drive in the chassis.
PCI/PCI-X/PCIe I/O Cards
A number of I/O cards is supported in the SEU PCI-X assembly. Known cards supported at the
release of this manual are shown in Table 3-1.
42 Installing the Server Expansion Unit