User Service Guide, Fifth Edition - HP Integrity rx8640 SEU

PDHC : B.023.003.037
PDC_FW : 043.006.000 - Active
PDC_FW : 043.005.000
Cell 2
PDHC : B.023.003.038 - Active
PDHC : B.023.003.037
PDC_FW : 043.006.000 - Active
PDC_FW : 043.005.000
Cell 3
PDHC : B.023.003.038 - Active
PDHC : B.023.003.037
PDC_FW : 043.006.000 - Active
PDC_FW : 043.005.000
IO Cabinet FPGA and Firmware revision report
PROGRAMMABLE HARDWARE :
System Backplane : GPM EMMUX
----------- -----------
001.002.000 001.000.000
IO Backplane : IO_LPM-0 IO_LPM-1
----------- -----------
001.003.000 001.003.000
Core IO : CIO-0 CIO-1
----------- -----------
001.002.000 001.002.000
FIRMWARE:
Core IO
MP-0 : B.002.005.012
ED-0 : 002.007.000
MP-1 : B.002.005.012
ED-1 : 002.007.000
If the SEU firmware requires an update, refer to the applicable rp8440/rp7440 and SEU firmware
release notes for download and update instructions.
Note that the SEU contains the following firmware and programmable hardware entities which
must be verified during installation:
PROGRAMMABLE HARDWARE:
System Backplane: GPM
System Backplane: EMMUX
IO Backplane: IO_LPM
Core IO: CIO
FIRMWARE:
Core IO: MP
Core IO: ED
Power Status
To invoke the system revision output, from the MP main menu enter cm. Then from the command
mode menu, enter ps.
Figure 4-12 shows the initial power status output. It lists the active devices in the system. To
obtain the status of an entire cabinet or portion thereof, enter the corresponding letter for the
menu choices shown in the figure. Example 4-2 shows full status output for cabinet 0.
Troubleshooting Aids 85