Windows Integrity Management Agents Reference

Event DescriptionEvent SeverityEvent ID
There was an error initializing the LBA Probable Cause: The LBA component
initialization routine failed. Recommended Action: This is an internal system firmware
error. Update system firmware or contact a system firmware representative. SNMP
Trap: hpevtIodiscLbaInitnodeError - 8715 in HPIFPTRAP.MIB.Warning8715
There was an error querying the LBA width Probable Cause: Error while writing the
LBA phase data Recommended Action: Replace the I/O backplane SNMP Trap:
hpevtIodiscLbaWidthError - 8716 in HPIFPTRAP.MIB.Error8716
There was an error with the LBA phase Probable Cause: Error while writing the LBA
phase data Recommended Action: Replace the I/O backplane SNMP Trap:
hpevtIodiscLbaPhaseError - 8717 in HPIFPTRAP.MIB.Warning8717
There was an error clearing the LBA Probable Cause: Unable to clear an error in the
LBA Recommended Action: Check other events for the error being generated replace
either the PCI card or the I/O backplane SNMP Trap: hpevtIodiscLbaClearError -
8718 in HPIFPTRAP.MIB.Warning8718
There was an error with the LBA log Probable Cause: The LBA component could not
generate error logs. Recommended Action: This is an internal system firmware error.
Update system firmware or contact a system firmware representative. SNMP Trap:
hpevtIodiscLbaLogError - 8719 in HPIFPTRAP.MIB.Error8719
There was an error discovering the LBA Probable Cause: The wrong backplane type
was detected Recommended Action: replace I/O backplane SNMP Trap:
hpevtIodiscLbaDiscoverError - 8720 in HPIFPTRAP.MIB.Error8720
There was an error configuring the LBA Probable Cause: Unable to configure the
LBA Recommended Action: replace I/O backplane SNMP Trap:
hpevtIodiscLbaConfigError - 8721 in HPIFPTRAP.MIB.Warning8721
There was an error scanning the PCI bus Probable Cause: Could not scan the card
in a populated slot. Typically caused by an improperly installed or faulty PCI card.
Recommended Action: Reseat or replace the faulty card. SNMP Trap:
hpevtIodiscLbaPciscanError - 8722 in HPIFPTRAP.MIB.Error8722
There was an error configuring PCI space through the LBA Probable Cause: Unable
to obtain semaphore Recommended Action: reset Update to latest recipe SNMP Trap:
hpevtIodiscLbaPciconfigError - 8723 in HPIFPTRAP.MIB.Error8723
The OLA cell failed accessing the complex profile Probable Cause: System firmware
was unable to lock either the global or the micro semaphore. Recommended Action:
Allow the OLA cell to reboot to BIB, then try the OLA operation again. Or, collect
IPMI event logs and contact HP Customer Support for assistance. SNMP Trap:
hpevtBootOlaCellErrAccessCmplxProfile - 8745 in HPIFPTRAP.MIB.Warning8745
Firmware was unable to find a suitable block of main memory to relocate ROM
Probable Cause: Probably caused by lots of PDT entries, or no main memory present.
SNMP Trap: hpevtBootFwRelocMemErr - 8747 in HPIFPTRAP.MIB.Error8747
Cell started OLA but is not configured in the complex profile of the partition. Probable
Cause: Cell was issued an OLA command without first updating the complex profile
to reflect its slot as configured in the partition. Recommended Action: Update the
complex profile to include the new cell. SNMP Trap:
hpevtBootOlaCellNotConfigInCmplxProfile - 8752 in HPIFPTRAP.MIB.Warning8752
The Options service received an NVRAM allocation error. Probable Cause: Invalidate
NVRAM and reset. SNMP Trap: hpevtOptsNvmAllocError - 8756 in HPIFPTRAP.MIB.Error8756
failure on OLA cell during attempt to synch its real-time clock Probable Cause:
Couldn't communicate with OLA cell. Recommended Action: Collect IPMI events
and contact HP Support. SNMP Trap: hpevtBootOlaUpdateRtcFailedOlaCell - 8757
in HPIFPTRAP.MIB.Warning8757
SAL errlog access timeout Probable Cause: Firmware is taking too long to process
requests. SNMP Trap: hpevtSalInfoTimeout - 8758 in HPIFPTRAP.MIB.Warning8758
Platform Agent Events 53