LIFT-O-FLEX® 17000 SP 400 Manual

Lift-O-Flex 17000 SP 400 Manual
Page 9 Rev July 01
Directional wheel locks
When moving a heavy load, it is both easier and safer if you use the directional wheel locks by moving
the red bar into the upper position. Both back wheels are now locked in a straightforward position. This
gives greater directional stability when moving heavy loads. Observe that it is especially important that a
heavy load be kept as low and as centered on the end-effector as possible.
3.2 Troubleshooting
The LIFT-O-FLEX has been designed to operate safely and effectively provided that maintenance
procedures are followed according to the instruction manual. A guide for trouble shooting is provided as
listed below should any problems arise. If the problem remains after referring to the troubleshooting
guide below - contact RONI, LLC in Charlotte, NC.
Symptom Action
1. The lifter does not run at all. A) Check the voltage of the battery (18 Volts).
B) Inside the power package where the batteries are
located is a 20-ampere fuse (T16L-250V). Check
that it's intact and operable.
C) Check that the connections to the battery charger
have been connected properly during recharge.
D) Check that the maximum load is not exceeded.
2. The end-effector cannot be A) Check that the mast is positioned correctly in
lowered or raised but the motor runs. the intermediate section. See above 2.1 Assembly.
3. The end-effector moves at a slower A) See above 1A, 1C and 1D.
speed than normal
4. When lifting there is a strange sound A) Attend the prescribed actions under 3.5
and/or the lifter operates differently Maintenance
than usual.