nPartition Administrator's Guide, Second Edition

4. Exit Partition Manager.
From Partition Manager Version 1.0, select the File→Exit action.
From Partition Manager Version 2.0, select Log off parmgr or exit the Web browser when
finished.
Configuring and Deconfiguring Cells
You can configure and deconfigure cells by using any one of the following procedures:
• “Configuring and Deconfiguring Cells (BCH Menu)” (page 213)
• “Configuring and Deconfiguring Cells (EFI Shell)” (page 214)
• “Configuring and Deconfiguring Cells (nPartition Commands)” (page 215)
• “Configuring and Deconfiguring Cells (Partition Manager)” (page 216)
You can deconfigure (make inactive) a cell that is assigned to an nPartition by setting its
use-on-next-boot value to "n" (do not use). This causes the cell to remain assigned to the nPartition,
but the cell will be inactive the next time its nPartition boots, meaning the cell hardware resources
will not be used.
Whenever you configure or deconfigure cells, you must reboot the corresponding nPartition for
the configuration change to take effect.
NOTE: Configuring and deconfiguring cells may be restricted based on any Instant Capacity
contract for the server complex.
Procedure 7-8 Configuring and Deconfiguring Cells (BCH Menu)
From the BCH Configuration Menu use the CELLCONFIG command to configure and deconfigure
cells assigned to the local nPartition. The BCH Menu is available only on HP 9000 systems.
1. Access the BCH Main Menu for the nPartition whose cells you want to configure or
deconfigure.
Login to the service processor (MP or GSP) and enter CO to access the Console list. Select
the nPartition console. When accessing the console, confirm that you are at the BCH Main
Menu (the Main Menu: Enter command or menu> prompt). If at a BCH menu other
than the Main Menu, then enter MA to return to the BCH Main Menu.
2. Enter CO to access the Configuration Menu.
3. From the BCH Configuration menu, use the CELLCONFIG command to list or set the
use-on-next-boot value for each cell.
• To list the use-on-next-boot values for all cells in the nPartition, issue the CELLCONFIG
command with no arguments.
• To change a cell use-on-next-boot value, issue the following command:
CELLCONFIG cell [ON|OFF]
where cell is the cell number, ON sets the cell use-on-next-boot value to "y" (yes, do use
the cell), or OFF sets the cell use-on-next-boot value to "n" (no, do not user the cell).
A cell that boots with a "y" (ON) use-on-next-boot value is permitted to rendezvous and
join its nPartition, thus becoming an active cell whose resources are used.
A cell that boots with a "n" (OFF) use-on-next-boot value does not rendezvous and thus
becomes an inactive cell whose resources are not used by its nPartition, although the
cell still is assigned to its nPartition.
Configuring and Deconfiguring Cells 213