nPartition Administrator's Guide, Second Edition

ri Reactivate with memory interleave (the default).
Specifies to integrate the cell into the nPartition
as normally occurs.
• Enhanced nPartition Commands only.
The clm value specifies the amount of memory that
will be configured as cell local memory for the cell.
The clm value specified using the -c option takes
precedence over the clm value specified using the -L
option.
You can specify the clm value in either of two forms:
percentage or absolute amount of memory. The default
is 0 (no cell local memory).
— Percentage cell-local memory (CLM).
The percent number can be any number in the
range 0-100 with a suffix of %.
This number is rounded to 12.5%, 25%, 37.5%,
50%, 62.5%, 75%, 87.5% or 100%. If the cell
contains less than 4 GBytes of memory, then the
percentage is rounded to 25%, 50%, 75% or 100%.
Percentages are rounded up or down to the
nearest value, but are not rounded up to 100%.
— Absolute CLM specification. (The default.)
The absolute number is interpreted as an absolute
number of gigabytes of memory and can
optionally have a suffix of GB.
As needed, an absolute CLM specification is
rounded up to the nearest 0.5 GBytes.
If the clm value is rounded, the command reports the
final value used.
-b path
Specifies the primary boot path.
For HP 9000 servers, this is the PRI boot path.
For HP Integrity servers, only boot options for the local
nPartition can be modified—therefore, boot paths for a
newly created nPartition cannot be set using parcreate.
Instead use the EFI system boot interface, available through
the nPartition console.
-t path
Specifies the alternate boot path.
For HP 9000 servers, this is the ALT boot path.
For HP Integrity servers, only boot options for the local
nPartition can be modified—therefore, boot paths for a
newly created nPartition cannot be set using parcreate.
Instead use the EFI system boot interface, available through
the nPartition console.
-s path
Specifies the secondary boot path.
For HP 9000 servers, this is the HAA boot path.
For HP Integrity servers, only boot options for the local
nPartition can be modified—therefore, boot paths for a
newly created nPartition cannot be set using parcreate.
Instead use the EFI system boot interface, available through
the nPartition console.
250 nPartition Commands