HP Superdome 2 Partitioning Administrator Guide (5900-2540, December 2012)

Getting MAC Addresses for Ignite-UX
The UEFI Shell command lanaddress can be used to list the MAC addresses of every network
interface in a partition:
Shell> lanaddress
LAN Address Information
LAN Address Path
----------------- ----------------------------------------
M 001 Mac(002655A9CA2A) PcieRoot(0x3)/Pci(0x0,0x0)/Pci(0x0,0x0)/MAC(002655A9CA2A,0x0)
002 Mac(002655A9CA2E) PcieRoot(0x3)/Pci(0x0,0x0)/Pci(0x0,0x1)/MAC(002655A9CA2E,0x0)
M 003 Mac(002655A9CA32) PcieRoot(0x3)/Pci(0x2,0x0)/Pci(0x0,0x0)/MAC(002655A9CA32,0x0)
004 Mac(002655A9CA36) PcieRoot(0x3)/Pci(0x2,0x0)/Pci(0x0,0x1)/MAC(002655A9CA36,0x0)
Task Summaries for Rebooting and Resetting Partitions
Table 6 describes the main nPartition boot and reset tasks and provides brief summaries and
references for detailed procedures.
You can perform the nPartition boot tasks in Table 6 (page 59) using either the OA CLI or the OA
GUI.
Table 6 nPartition Boot and Reset Task Summaries
SummaryTask
Boots the partition. See “POWERON PARTITION” (page 63).POWERON (pe)
1
Shuts down the partition. See “POWEROFF PARTITION” (page 60).POWEROFF (pe)
Reboots the OS on the specified nPartition or virtual partition. See “REBOOT
PARTITION” (page 63).
REBOOT (rs)
Connect or disconnect the DVD module to the specified partition. See “SET
PARTITION DVD” (page 64).
SET PARTITION DVD
Performs a transfer-of-control reset of the specified nPartition or virtual
partition. See “Force System Reset and Crash Dump (TOC) PARTITION”
(page 68).
TOC (tc)
Displays information about the TRAY, LCD, FAN and so on. See “UPDATE
SHOW FIRMWARE” (page 72).
UPDATE SHOW
Displays information about the DVD drive attached to the specified partition.
See “SHOW PARTITION DVD” (page 67).
SHOW PARTITION DVD
Displays information about the specified partition(s). See “SHOW PARTITION
INFO” (page 68).
SHOW PARTITION INFO
The UPDATE NPARTITION command downloads a new flash image from
the network or a USB drive attached to the DVD module, or a DVD in the
UPDATE NPARTITION
enclosure DVD drive in the monarch enclosure and uses it to update the
firmware for HP Superdome 2 cell blades within the specified partitions.
See“UPDATE NPARTITION” (page 70).
Displays the version of the firmware bundle currently installed on the server
blades within the specified partitions. See “UPDATE SHOW FIRMWARE”
(page 72).
UPDATE SHOW NPARTITION
Updates the Superdome system's firmware (except I/O firmware). See
“UPDATE FIRMWARE” (page 71).
UPDATE FIRMWARE
Displays the configured Superdome firmware version and lists any of the
following Superdome 2 devices whose installed firmware version differs
UPDATE SHOW FIRMWARE
from the system's configured firmware version: blade, XFM, SIOX, OA,
GPSM. See “UPDATE SHOW FIRMWARE” (page 72).
Task Summaries for Rebooting and Resetting Partitions 59