HP JetDirect 400N Print Server Hardware Installation Guide - 5969-3587

Installing the HP JetDirect Print Server Card 2-21
2
Installation
4. For the HP JetDirect card that will be installed into the upper
slot, remove the front plate by removing the two side screws (A).
• If your HP JetDirect card is a Token Ring card, also remove
the mounting screws (B) from the front plate.
• The front plate should separate from the card. Save this front
plate for future use, if desired.
5. Obtain the appropriate custom cover plate for your card.
Remove the plastic clip and screws from the rear of the cover
plate. Save the clip—you will use it later in the installation
process.
Remove faceplate from card
Custom cover plate for Token Ring card