HP LaserJet Pro M1530 - Software Technical Reference

●

Minimum Font Size to Download as Outline

●

Maximum Font Size to Download as Bitmap

Available PostScript Memory

This option specifies the amount of available postscript memory and provides a spin box for changing

the value. The available postscript memory is a subset of the total product memory. It is usually best

to set the postscript memory to match the total RAM that appears on the configuration page.

To print a configuration page from the product control panel:

1. On the product control panel, press Setup

2. Use the arrow buttons to select Reports, and then press OK.

3. Use the arrow buttons to select Config Report, and then press OK.

Output Protocol

This option specifies the protocol that the product uses for print jobs. The following options are

available:

●

ASCII (default)

●

TBCP

●

Binary

Click ASCII to send data in ASCII format (7-bit), which might take longer to print but can be sent

through any I/O channel, such as a serial or network port.

Click TBCP (Tagged Binary Communications Protocol) to send all data except special control

characters in binary (8-bit) format. The binary formats can be sent over serial communications ports

and are faster than sending data in ASCII format.

Click Binary to send all data except special control characters in binary (8-bit) format. The binary

formats can be sent over serial communications ports and are faster than sending data in ASCII

format.

Send Ctrl-D Before Each Job

This option specifies whether the product is reset at the beginning of every postscript document. The

default setting is No. Pressing Ctrl-D resets the product to its default setting to ensure that previous

print jobs do not affect the current print job. Using Ctrl-D might cause a print job to fail if the product is

connected through a network. If the document fails to print when sent to a product connected through

serial ports, change No to Yes.

Send Ctrl-D After Each Job

This option specifies whether the product is reset at the end of every postscript document. The

default setting is Yes. Pressing Ctrl-D resets the product to its default setting to ensure that future

print jobs are not affected by the current print job. Using Ctrl-D might cause a print job to fail if the

product is connected through a network. If the document fails to print when sent to a network product,

change Yes to No.

ENWW

Device Settings tab features