HP LaserJet P3005 - User Guide

Control panel message Description Recommended action
Unauthorized supply in use
alternates with
Ready
The device has detected that a non-
HP supply is currently installed and
(override) was pressed.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs required as a result of using
non-HP supplies are not covered under
HP warranty.
USB ACCESSORY ERROR The device has detected too much current on
the USB storage accessory.
●
Turn the device off.
●
Remove the USB storage accessory.
●
Replace the USB storage accessory.
●
Turn the device on.
USB Storage <X> initializing The USB storage device is initializing. No action necessary.
USB Storage <X> not functional The USB storage device is not working. Replace the USB storage device.
USB STORAGE DEVICE FAILURE
alternates with
Ready
To clear press
The USB storage device has failed.
●
Printing can continue for jobs that do not
require the storage device.
●
To remove this message from the
display, press
.
●
If the message persists, turn the device
off, remove and re-install the storage
device, and then turn the device on.
●
If the message persists, replace the
storage device.
USB STORAGE FILE OPERATION FAILED
alternates with
Ready
To clear pressTo clear press
The device received a PJL file system
command that attempted to perform an
illogical operation (for example, to download
a file to a nonexistent directory).
●
Printing can continue.
●
To remove this message from the
display, press
.
●
If the message reappears, a problem
might exist in the software program.
USB STORAGE FILE SYSTEM IS FULL
alternates with
Ready
To clear press
The device received a PJL file system
command that attempted to store something
on the file system but was unsuccessful
because the file system is full.
●
Use HP Web Jetadmin software to
delete files from the storage device, and
then try again.
●
To remove this message from the
display, press
.
USB STORAGE IS WRITE PROTECTED
alternates with
Ready
To clear press
The file system is protected and no new files
can be written to it.
●
To enable writing to the storage device,
use HP Web Jetadmin to turn off write
protection.
●
To remove this message from the
display, turn the device off and then on.
ENWW Control-panel messages 125