HP LaserJet P3005 - User Guide

5. Make sure that the type and quality of the media you are using meet HP specifications. (See Media
considerations.)
6. Make sure that the environmental specifications for the device are being met. (See
Operating
environment.)
Curl or wave
1. Turn over the media in the tray. Also, try rotating the media 180°.
2. Make sure that the type and quality of the media you are using meet HP specifications. (See
Media
considerations.)
3. Make sure that the environmental specifications for the device are being met. (See
Operating
environment.)
4. Try printing to a different output bin.
5. If media is lightweight and smooth, open the CONFIGURE DEVICE menu at the device control
panel. On the PRINT QUALITY submenu, select FUSER MODES, and then select the media type
you are using. Change the setting to LOW, which helps reduce the heat in the fusing process.
(See
Print Quality submenu.) You must also set the type of media for the tray you are using.
(See
Control print jobs.)
Wrinkles or creases
1. Print a few more pages to see if the problem corrects itself.
2. Make sure that the environmental specifications for the device are being met. (See
Operating
environment.)
3. Turn over the media in the tray. Also, try rotating the media 180°.
4. Make sure that media is loaded correctly and all adjustments have been made. (See
Load
media.)
5. Make sure that the type and quality of the media you are using meet HP specifications. (See
Media
considerations.)
6. If envelopes are creasing, try storing envelopes so that they lie flat.
ENWW Solve print-quality problems 143