LASERJET PROFESSIONAL M1130/M1210 MFP SERIES User Guide Addendum Wireless Models Only
HP LaserJet Professional M1130/M1210 MFP series User Guide Addendum (wireless models only) Use this addendum in conjunction with the complete version of the product user guide.
Copyright and License Trademark Credits © 2011 Copyright Hewlett-Packard Development Company, L.P. Microsoft®, Windows®, Windows® XP, and Windows Vista® are U.S. registered trademarks of Microsoft Corporation. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained herein is subject to change without notice.
Conventions used in this guide TIP: Tips provide helpful hints or shortcuts. NOTE: Notes provide important information to explain a concept or to complete a task. CAUTION: Cautions indicate procedures that you should follow to avoid losing data or damaging the product. WARNING! Warnings alert you to specific procedures that you should follow to avoid personal injury, catastrophic loss of data, or extensive damage to the product.
iv Conventions used in this guide ENWW
Table of contents 1 Product basics .................................................................................................................. 1 Product views .......................................................................................................................... 2 Control-panel layout .................................................................................................. 2 2 Control panel menus ............................................................................
European Union regulatory notice ............................................................................. 22 Notice for use in France ........................................................................................... 23 Notice for use in Russia ........................................................................................... 23 Korean statement .................................................................................................... 23 Taiwan statement ....................
1 Product basics ● ENWW Product views 1
Product views Control-panel layout HP LaserJet Professional M1210 MFP series (wireless models only) 4 5 6 7 3 2 1 16 8 9 10 15 2 14 13 12 11 1 Toner-level status light: Indicates the level of toner in the print cartridge is low. 2 Attention light: Indicates a problem with the product. View the LCD display for a message. 3 Ready light: Indicates the product is ready or is processing a job. 4 LCD display screen: Displays status information, menus, and messages.
13 Redial button: Recalls the last digits used for the previous fax job. 14 Darker/Lighter copy button: Adjusts the darkness setting for the current copy job. 15 Numeric keypad: Use the keypad to enter fax numbers or to enter data. 16 Wireless button and status light: Use the button to turn off or turn on the product wireless function. The status light indicates wireless operation. ENWW ● On: The product is connected to a wireless network.
4 Chapter 1 Product basics ENWW
2 Control panel menus ● ENWW Control-panel menus 5
Control-panel menus For the HP LaserJet Professional M1210 MFP series (wireless models only), the Wireless Menu submenu is available from the control-panel Network config. menu. ● Use the Wireless Menu sub-menus to enable, disable, test, or set up the product wireless functions. Table 2-1 Wireless Menu sub menus Menu item Sub-menu item Description Wireless Menu Wireless Radio Enable or disable the product wireless radio functionality. On Off The default setting is On.
3 Connect the product ● ENWW Network connection 7
Network connection The product can connect to wireless networks. Install the product on a wireless network with HP Smart Install NOTE: This installation type is supported for Windows only. The HP Smart Install allows you to install the product driver and software by connecting the product to a computer through a USB cable. If the product previously has been installed on a network, restore the default wireless settings. NOTE: The installation CD is not required during a HP Smart Install.
Install the product on a wireless network with the software CD 1. Insert the software CD into the computer CD tray. If the installation program does not start automatically, browse the CD contents and run the SETUP.EXE file. 2. Follow the onscreen instructions to complete the product installation. 3. When the installation is complete, if you want to verify that the product has a network IP address, print a configuration page. a. On the product control panel, press the Setup b.
Alternate method to restore the default wireless settings 2. a. Turn the product off. b. Press and hold the wireless c. Hold the buttons until all of the lights blink in unison, and then release the buttons. button and the cancel button, and then turn the product on. Print a configuration page, and find the network name (SSID) in the Network Information section. a. On the product control panel, press the Setup b. Use the arrow buttons to select the Reports menu, and then press the OK button.
Turn off the product wireless unit If you want to disconnect the product from a wireless network, you can turn off the wireless unit in the product. 1. At the product control panel, press and hold the Wireless 2. To confirm that the wireless unit is turned off, print a configuration page, and then verify that the 802.11b/g wireless status item on the configuration page is disabled. button for more than 5 seconds. a. On the product control panel, press the Setup b.
Alternate method to restore the default wireless settings 12 a. Turn the product off. b. Press and hold the wireless c. Hold the buttons until all of the lights blink in unison, and then release the buttons. Chapter 3 Connect the product button and the cancel button, and then turn the product on.
4 Print tasks ● ENWW Use HP ePrint 13
Use HP ePrint HP ePrint is a suite of Web-based printing services that enable a supported HP product to print documents of the following types: ● E-mail messages and attachments sent directly to the HP product’s e-mail address ● Documents from select mobile device print applications Use HP Direct Print Use HP Direct Print to print directly to the product from any mobile device (such as a smart phone, net book, or laptop computer). NOTE: No setup is necessary, but HP Direct Print must be enabled.
5 Solve problems ● ENWW Solve connectivity problems 15
Solve connectivity problems Solve wireless problems The installation program cannot detect the product during the setup process. Cause Solution The product is off. Verify that the product is on and ready. Restart the product if necessary. The product is too far away from the wireless router or access point. Move the product closer to the wireless router or access point. A personal firewall program is blocking communication. Temporarily disable the firewall program to install the product.
The product cannot connect to the wireless network. Cause Solution The product wireless settings and the network settings do not match. You might need to configure the product network settings manually. Verify that you know the following network settings: ● Communication mode ● Network name (SSID) ● Channel (ad-hoc networks only) ● Authentication type Use the Wireless Configuration utility to configure the product to print on wireless network.
18 Chapter 5 Solve problems ENWW
A ENWW Regulatory information ● Declaration of Conformity (wireless models) ● Additional statements for wireless products 19
Declaration of Conformity (wireless models) Declaration of Conformity according to ISO/IEC 17050-1 and EN 17050-1 Manufacturer's Name: Hewlett-Packard DoC#: BOISB-0901-05-rel.1.0 Information Technology R&D (Shangai) Co., Ltd Manufacturer's Address: Building 6, No.
Supplementary Information: The product herewith complies with the requirements of the EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC, the R&TTE Directive 1999/5/EC (Annex II & Anex IV), the EuP Directive 2005/32/EC and carries the CE-Marking accordingly. This Device complies with Part 15 of the FCC Rules.
Additional statements for wireless products FCC compliance statement-United States Exposure to radio frequency radiation CAUTION: The radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such a manner that the potential for human contact during normal operation is minimized.
Netherlands, Norway, Poland, Portugal, Romania, Slovak Republic, Slovenia, Spain, Sweden, Switzerland, and United Kingdom. Notice for use in France For 2.4 GHz Wireless LAN operation of this product certain restrictions apply: This equipment may be used indoor for the entire 2400-2483.5 MHz frequency band (channels 1-13). For outdoor use, only 2400-2454 MHz frequency band (channels 1-9) may be used. For the latest requirements, see www.arcep.fr. L'utilisation de cet equipement (2.
Vietnam Telecom wired marking for ICTQC Type approved products 24 Appendix A Regulatory information ENWW
Index C connectivity solving problems 16 control panel buttons and lights 2 menus 6 D document conventions E ePrint HP Direct Print using 14 iii 14 H HP Direct Print using 14 P problem-solving connectivity 16 wireless problems 16 R restore, wireless settings 11 S settings, wireless restore default 11 solving wireless problems 16 ENWW Index 25
26 Index ENWW
© 2011 Hewlett-Packard Development Company, L.P. www.hp.
