9.0 HP StorageWorks P4000 VSA Installation and Configuration Guide

4. Finish the installation, reviewing the configuration summary.
When the installer is finished, the VSA is ready to be used in the P4000 SAN Solution.
5. Next, install the CMC, described in Chapter 4. Then follow the steps in “Getting started with the
CMC” on page 17.
The installer may take a few minutes to complete, depending upon the underlying hardware.
Troubleshooting
Table 5 Troubleshooting the Hyper-V VSA installation
SolutionProblem
1. Close the installer.
2. Verify that the disks are offline.
3. Start the installer again.
While installing the Hyper-V VSA, you do not see the
physical disks you prepared.
Installing the P4000 VSA for Hyper-V16