SVS200 LUN Manager and Volume Manager (T1714-96015, October 2007)

Figure 74 Specify Authentication Information pane

Specify the following user information for the port or iSCSI target selected in the Port tree:

• Target Name: Selected port's iSCSI name. You cannot change the iSCSI name.

• User Name: iSCSI target's user name up to 128 characters. You can use alphanumeric

characters, spaces, and the following symbols in a user name:

.-+@_=:/[],~

User names are case-sensitive. For example, port1 and Port1 represent different user names.

• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32

characters. You can use the same characters and symbols as a user name.

• Re-enter Secret:Specifythesecretagainforconﬁrmation.

4. Click OK.Thespeciﬁed user information for the port appears in blue in the Authentication

information (Target) list.

5. Click Apply.Aconﬁrmation message appears.

6. Click OK. Settings are applied to the array.

Clearing an iSCSI target's user information (when performing mutual

authentication)

1. Start LUN Manager, and display the Authentication pane (Figure 30).

2. In the Port tree, expand the iSCSI folder, and select the port or iSCSI target whose user information

you want to clear. The currently registered user information for the port or iSCSI target appears in the

Authentication Information (Target) list on the right of the tree.

3. Right-click any point in the Authentication information (Target) list, and select Clear Authentication

Information. The Clear Authentication Information pane appears.

4. Click OK. The selected iSCSI target's user information disappears from the Authentication information

(Ta

rget)list.

5. Cl

ick Apply.Aconﬁrmation message appears.

6. Click OK. Settings are applied to the array.

Settings and connection results in authentication of hosts (iSCSI environments)

During authentication of hosts, the connection result is determined based on the combination of the

following iSCSI target settings:

• i

SCSI target's setting in the Port tree: enable (

)ordisable( )

HP StorageWorks LUN Conﬁguration and Security Manager XP user guide for the

XP12000/XP10000/SVS200

129