HP Insight Orchestration 6.3 User Guide

folder highlighted in the following screenshot, enter 01 in front of the 1st job, Deploy ProLiant
System Configuration (BL BFS); enter 02 in front of the 2nd job, DeployRHEL 5.4 x64 (EN-US);
enter 03 in front of the 3rd job, Install HP Management Agents for RHEL 5 x64. For
Direct-Attached Storage (DAS) OS deployment, do not include the Deploy ProLiant System
Configuration (BL BFS) job in the job folder.
5. To create a job folder for each required operating system, repeat this procedure.
6. To enable adding computers to the domain during provisioning, configure the Insight Control
server deployment domain authorization using Tools→Options→Domain Accounts.
Enclosures are discovered by Systems Insight Manager through the iLO IP address of the
enclosure. Be sure to use the iLO credentials of the Onboard Administrator enclosure as the
WBEM credentials.
7. In HP Insight Dynamics, create storage pool entries for automated SAN boot provisioning.
You must know the storage array port WWN/LUN (World Wide Name/Logical Unit Number)
when creating the entries. If you do not know these settings, you can modify them after creating
storage LUNs and zones. See “Creating SAN-backed storage” (page 31).
8. Manually configure storage LUN presentation and zoning using the virtual HBA WWN in VC
profiles used when creating the storage pool entries. HP recommends creating a spreadsheet
to track storage mapping.
During provisioning, the server blade should see a SAN volume when booting. If it does not, check
your storage configuration settings.
Modifying the Erase ProLiant Hardware job
After installing HP Insight Control server deployment software, you must modify the default Erase
ProLiant Hardware job. To modify the job, do the following:
1. Save a copy of the default Erase job:
Configuring deployment servers 17