HP Insight Orchestration 6.3 User Guide

6. Select the user in the Unassigned Users/Groups list and then click >>. Repeat this process for
each user you want to assign to the pool. Click Save. The Servers page reappears.
To verify that the users are assigned to the pool, select the pool. A list of the assigned users
and groups appears at the bottom of the screen.
Configuring Insight Orchestration to list heterogeneous hardware
To integrate with non-HP based servers or HP rack mount servers, HP recommends the use of the
ESA (Extensible Storage and Server Adapter) bundled with HP Insight Dynamics for use with the
logical server capabilities of Virtualization Manager. ESA includes integration with the Insight
Dynamics embedded Operations Orchestration engine, and enables the definition and execution
of workflows for loading server inventory and for performing basic power control. Several server
types and configurations may integrate into Insight Orchestration using ESA in Insight Dynamics.
• Non-HP servers
• HP rack mount servers
• HP c-Class blades (not managed by Virtual Connect)
For each of the server types referenced above, the following storage configurations are supported:
Boot Disk
• A SAN (Fibre Channel) attached disk
• A local (direct attached) disk. If using an on-board RAID controller, only a single logical volume
is supported.
Data Disk(s)
• One or more SAN (Fibre Channel) attached disks
The included reference workflow for controlling server power supports the following server
management processors:
• ProLiant iLO2
• Integrity iLO2
40 Configuration