HP Insight Orchestration 6.3 User Guide

Task for logical server <logical server name> …. Failure: At least one
OS or software deployment has failed. Check the deployment service to
diagnose the details.
Failure message
Possible cause
• Problem with a LUN allocated to server or firmware issue on server
• Insight Control server deployment Erase ProLiant ML/DL/BL Array Configuration
{LinuxPE} job has not been modified for Insight Orchestration.
To verify the LUN and/or server firmware:Action
1. Use Remote desktop and log into the server deployment server.
2. Verify that the server deployment console for the enclosure bay for the logical server XYZ. The
message should state RDeploy: The disk was not found.
3. From the request messages, identify the LUN that has been allocated to the logical server.
4. If the message indicates a possible server WWN issue with the LUN, see “Configuring storage
pool entries, FC zones, and disk array presentations” (page 114).
5. If you suspect a firmware error, use iLO to observe the progress of booting the server. If the
message WARNING Adapter NVRAM contains invalid data displays, press <ALT-Q>
to enter Fast!UTIL and reset the adapter defaults. For more information, see “Correcting a
checksum error” (page 117).
6. Perform a manual clean-up process for any affected logical server. See “Manual clean-up process
(physical)” (page 112).
To modify the Insight Control server deployment job:
1. Follow Step 9 in the Creating server deployment job folders procedure. The job must have only
two steps:
DetailsTask
Wipe DiskRun Script
Shutdown (if
available)
Power Control
2. Perform a manual clean-up process for any affected logical server.
Provisioning request for <service_id> has paused. Manual data disk
allocation is required.
Failure message
This error indicates that insufficient LUNs exist to provision the service.Possible cause
Create the LUNs and continue provisioning.Action
Task for logical server <logical_server_id> has failed. Logical server
job (ID = …) completed with a failure status. The deployment server does
Failure message
not have the specified system UUID recorded. Deployment Service Connector
cannot confirm the system UUID provided by the caller.
The deployment server cannot bootstrap the server. This issue can occur if the LUN attached to the
server already has an OS deployed to it such that the server is booting from the presented LUN
rather than booting into the designated deployment server.
Possible cause
Action 1. Locate the Provisioning logical server message which identifies the server blade in
use.
2. Perform a manual clean-up process for any affected logical server. See “Manual clean-up process
(physical)” (page 112).
86 Troubleshooting