HP Matrix Operating Environment 7.3 Recovery Management User Guide

configuration process and to help ensure that the two sites have synchronized configurations, you
can export the Matrix recovery management configuration information to a file at the Local Site,
move that file to the Remote Site, and then import the Matrix recovery management configuration
information at the Remote Site.
Figure 3 Configuration steps
NOTE: Make sure all of the steps in “ Setting up Remote Site logical servers” (page 16) have
been completed, before you attempt the following Matrix recovery management configuration
steps at the Local Site.
1. From the Sites tab, configure the Local Site.
2. From the Storage Management Servers tab, configure Storage Management Servers at the
Local Site.
3. From the Storage Replication Groups tab, configure Storage Replication Groups at the Local
Site.
4. From the Recovery Groups tab, configure Recovery Groups at the Local Site.
NOTE: Matrix recovery management allows failover of the logical servers or the IO services
in a Recovery Group, independent of the associated Storage Replication Groups. This capability
is referred to as Storage Decoupling.
5. From the Sites tab, create an export file at the Local Site. For information on export and import
parameters, see “Matrix recovery management export and import operations” (page 20).
6. From the Sites tab at the Remote Site, import the Local Site Matrix recovery management
configuration. For more information, see “Matrix recovery management export and import
operations” (page 20).
7. Test the recovery logical servers. All imported Recovery Groups are in maintenance mode,
allowing activation of the recovery logical servers. For more information, see “Testing Recovery
Groups” (page 27).
Configuring Matrix recovery management 19