HP StorageWorks 600 Modular Disk System Maintenance and Service Guide

Removal and replacement procedures 31

Disconnect the cable from the display board.

To replace the component, reverse the removal procedure.

Fan

IMPORTANT: Configurations using power cord part number 142263-004, located on the

power cord label, require that the power cord be removed before removing a fan.

Before removing a fan, do the following:

• Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page 57).

• Be sure that your configuration can support your actions. If the proper redundancy is not in place,

power down the MDS600 before beginning this procedure.

To remove the component:

1. Be sure that the hard drive drawer is closed.