HP StorageWorks 600 Modular Disk System Maintenance and Service Guide

Removal and replacement procedures 33

Release the I/O handle, push the I/O handle down until it ejects the I/O module, and then remove the

I/O module.

CAUTION: For best cooling practices, do not operate the enclosure for extended periods with

more than one component or blank removed. When removing an active component permanently,

replace it with a blank.

To replace the component, reverse the removal procedure. Be sure the I/O module is fully seated and the I/O

module handle is in the locked position.

I/O module blank

CAUTION: For best cooling practices, do not operate the enclosure for extended periods with

more than one component or blank removed. When removing an active component permanently,

replace it with a blank.