HP StorageWorks 600 Modular Disk System Maintenance and Service Guide

Removal and replacement procedures 49
15.
Disconnect the cables.
When reconnecting the cables, use the following illustration and table to be sure the cables are properly
reconnected.
Item Description
1
Fan signal cable
2
Red 12V power cable
3
Black GND cable
4
Fan power cable
5
Power signal cable
1. Thread the cables through the opening in the drawer.
2. Remove the cable management arm.
To replace the cable management arm:
1. Thread the cables through the opening in the drawer, and then connect them to the backplane board.