Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access EVA A.05.01

Starting the complex workload in the Metrocluster
To start the disaster tolerant complex workload:
1. Run the cmviewcl command to view the complex workload configuration in a Metrocluster.
2. Enable all nodes in the Metrocluster for the Site Controller package.
# cmmodpkg –e –n <site1node_1> –n <site1node_2> -n <site2node_1> –n
<site2node_2> cw_sc
3. Start the Site Controller Package.
# cmmodpkg -e cw_sc
The Site Controller package and the complex-workload package starts up on the local site.
4. Check the Site Controller Package log file to ensure clean startup.
48 Configuring complex workloads using Site Aware Disaster Tolerant Architecture (SADTA)