Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access EVA A.05.01

Table 8 Error messages and their resolution (continued)
ResolutionCauseLog Messages
properly and is functioning
correctly.
3. Restart the Site Controller package.
There is no Metrocluster
Environment file in the
Error: Metrocluster Environment file does not exist in
/etc/cmcluster/hrdb_sc
1. Restore the Metrocluster
Environment file under the Site
Controller package directory.Site Controller package
directory on the node
2. Check if the Metrocluster
Environment file is named using the
where Site Controller
package failed.
Metrocluster defined naming
convention.
3. Restart the Site Controller package.
There is more than one
Metrocluster
Error: More than one environment files are found in
/etc/cmcluster/hrdb_sc.
1. Remove the redundant file.
2. Restart the Site Controller package.
Environment file in the
Site Controller package
directory on the node
where Site Controller
failed.
The Site Controller
package failed to
Error: Failed to import CVM DG <CVMDG name> 1. Check the syslog on the site CVM
master node.
import the CVM Disk
2. Check the disk group status using
VxVM commands.
Group on the site it
failed to start.
3. Identify and fix any issues.
4. Restart the Site Controller package.
The Site Controller
package failed to
Error: Failed to deport CVM DG <CVMDG Name> 1. Check the syslog on the site CVM
master node.
deport the CVM Disk
Group on the other site.
2. Check the disk group status using
VxVM commands.
3. Identify and fix any issues.
4. Restart the Site Controller package.
If the cluster is reforming, ignore these
error messages.
This message is logged
because the cluster is
Message logged in the syslog file.
Warning: Site Controller
<site_controller_package_name> not able to set the
If the cmviewcl command fails
because of a memory, network or CPU
transient error condition, fix the issue.
reforming or because
of transient error
conditions.
Site Safety Latch value to <value> on node
<node_name>.
Check the Site Controller package
<site_controller_package_name> log for more details.
Remove the comments specified after
the values of the
critical_package parameter.
This message appears
because a comment is
specified after the
critical_package
When you the cmapplyconf -f -P
hrdb_sc.config command, the following message
is displayed:
Failed to validate
/etc/cmcluster/scripts/mscripts/master_control_script.sh.
parameter value in Site
Controller package
configuration file.
On node <node_name> validation failed with:
/etc/cmcluster/scripts/dts/sc.sh[49]:
SC_CRITICAL_PACKAGE: The specified subscript
cannot be greater than 1024.
ERROR: Failed to validate
/etc/cmcluster/scripts/dts/sc.sh
Troubleshooting Metrocluster SADTA 73