HP mc-Series 5042 Rack Options Installation Guide

Automatic Door Release Kit 14
To install the front strike plate:
1. Using a T-25 Torx screwdriver, remove the two M5.5 x 10-mm screws from the inside of the rack front
door.
2. Align the strike plate bracket to the holes on the rack front door.
3. Using a T-25 Torx screwdriver, insert and then tighten the two M5.5 x 13-mm screws to attach the strike
plate bracket to the rack.
4. Assemble the strike plate:
a. Insert a flathead screw through the strike plate (2).
b. Slide a rubber washer onto the flathead screw in between the strike plate and strike plate bracket
(3).
NOTE: Do not tighten the strike plate too tightly to the strike plate bracket. The strike plate should
float on the rubber washer providing flexibility to align with the electromagnetic lock.
5. Install the strike plate.